Panchroma™ is a new family of engineered polymer compounds containing PLA. The formulations are fine tuned for each color/surface finish to offer the best aesthetic quality and printability. They can be reliably printed on any FFF/FDM 3D printer under typical PLA settings.

All Panchroma™ prodcuts are PLA except for those listed under "experimental".

PolyLite PLA effects have been rebranded under the Panchroma family. Galaxy PLA is now Panchroma Galaxy, Starlight PLA is now Panchroma Starlight, and so on.

Standard PolyLite™ PLA is still going through some rebranding name changes, but you can find it right HERE

PolyTerra™ products have been rebranded under the Panchroma™ family. Standard PolyTerra™ PLA is now Panchroma™ Matte. PolyTerra™ Gradient PLA is now Panchroma™ Gradient Matte. PolyTerra™ PLA + is now Panchroma™ Satin.

No formulas have changed, just rebranded to be easier to find the product you are looking for. You can still grab all of our old branded spools by clicking on "old" in the product while we transition.

Panchroma™ CoPE is a new experimental product that is not PLA. It prints with very similar settings as PLA but can achieve better overhangs at faster speeds.

That said - it does not stick to PLA very well and therefore should not be combined with other Panchroma™ PLA Products in a single print. It also sticks very well to textured PEI plates, therefore we only recommend using Panchroma™ CoPE with a textured PEI plate if used with Magigoo Original.

The short answer is yes - all Panchroma™ PLA products can be combined into a single print. However please note that the layer adhesion of Panchroma™ Regular with other Panchroma™ color ranges is weaker which can cause delamination in your Hueforge print. We can suggest PolyLite™ PLA to combine with other color ranges for Hueforge applications.

Yes! We have redesigned the edges of our spools so all Panchroma™ products will now spin great in the AMS.